PM-200 – Ready Mix Plaster
USES
Ready-Mix Plaster PM-200 is render mortar which is specifically applicable to light weight substrates such as light-weight-concrete blocks and panels. The response to fluctuative temperature on the surface is very satisfied.
ADVANTAGES
- Good Consistency of the mixture.
- Quick and easy to work with.
- Fixed volume in application.
- Good bonding strength.
- Reduce cost.
SPECIFICATION AND PROPERTIES
- Colour: Light Grey
- Binder: Portland Cement
- Aggregate: Silica Sand up to 1.2 mm maximum size
- Filler: Lime Powder
- Additives: Water soluble additives to improve workability, durability and bonding.
- Water demand: 7.0 – 7.5 l/40 kg
- Open Time: 10 – 15 minutes
- Dry density: 1.6 kg/l
- Wet density: 1.7 kg/l
- Mix of comparison: 4.8 kg/l clean water
- Coverage Area: +/- 2 m²/40 kg/10 mm
- Compressive Strength: > 10 N/mm² after 28 days
- Flexural strength: > 4 N/mm² after 28 days
- Thickness for application: 10 – 15 mm
- Adhesion strength
- Shear method: > 1.5 N/mm² after 28 days
- Pull Out Method: > 2 N/mm² after 28 days
- Pull Off Strength: > 0.5 N/mm² after 28 days ( BS 4551 : 1980 )
PREPARATION
• Clean the wall surface from dust, dirt, and other material which may effect the bonding effectiveness.
• Machine mixing is highly recommended.
• Gradually add ready-mix plaster into a container containing clean tap water and mixing thoroughly until an even consistency is achieved for around 4 minutes.
• Thorough mixing is important for all premixed products.
APPLICATION
• Do not apply in hot and windy conditions, as the mixture will be dry too quickly.
• Recommended bed thickness is 10 - 15 mm.
• Render should be applied minimum 24 hour after block laying using PM-100, to give the adhesive mortar an adequate setting time.
STORAGE
Always store in dry place away from contact with moisture and water.
PACKAGING
Multi layer with inner polyethylene liner 40 kg paper bag.
Ready-Mix Plaster PM-200 storage time should not exceed 12 months.
